Harken 20ST Winche Manual do Utilizador

Radial Winch 20 STInstallation and Maintenance ManualMRW-02

10Radial Winch 20 STInstallation and Maintenance ManualCarry out Procedure1 as shown in the paragraph on winch installation and then do the following

11Radial Winch 20 STInstallation and Maintenance ManualIf it is necessary to replace any jaws of the winch, proceed as follows:If it is necessary to r

12Radial Winch 20 STInstallation and Maintenance ManualExplodedviewwithmaintenanceproductsGGAAHarken® GreaseGHarken® Pawl OilOLoctite® 270LAnti-se

13Radial Winch 20 STInstallation and Maintenance ManualAssemblyMake sure that the holes and drainage channels in the base of the winch are not obstruc

14Radial Winch 20 STInstallation and Maintenance ManualHarken®limitedworldwidewarrantyRefer to the Harken® Limited Worldwide Warranty in the Harke

15Radial Winch 20 STInstallation and Maintenance ManualExploded viewExplodedview21451145736109141315161217181920845

16Radial Winch 20 STInstallation and Maintenance Manual21451145736109141315161217181920845

17Radial Winch 20 STInstallation and Maintenance Manual*Servicekitavailable;seewinchkitsectiononthewebsitewww.harken.com**Winchproductstic

18Radial Winch 20 STInstallation and Maintenance ManualRadialWinch20STCC=drum in chromed bronze*Servicekitavailable;seewinchkitsectiononthe

19Radial Winch 20 STInstallation and Maintenance ManualRadialWinch20STCWC=drum in chromed bronze - W=components RAL 9003*Servicekitavailable;see

2Radial Winch 20 STInstallation and Maintenance ManualIndexIntroduction 3Technicalcharacteristics 3Weights 3Maximumworkingload 3Outline 3Insta

3Radial Winch 20 STInstallation and Maintenance ManualIntroduction - Technical characteristics - OutlineIntroductionThis manual gives technical inform

4Radial Winch 20 STInstallation and Maintenance ManualInstallationThe winch must be installed on a at area of the deck, reinforced if necessary to be

5Radial Winch 20 STInstallation and Maintenance ManualThe winch can be installed following one of the two procedures below (Procedure1 or Procedure2)

6Radial Winch 20 STInstallation and Maintenance ManualProcedure2To install, you must remove the winch skirt and use hexagonal headed bolts.Tools need

7Radial Winch 20 STInstallation and Maintenance ManualNOTICEMake sure the skirt is correctly clipped on to the base of the winch. Install the winch on

8Radial Winch 20 STInstallation and Maintenance ManualB. Remove the winch and drill the ve 6.2 mm diameter holes.C. Bolt the base of the winch to the

9Radial Winch 20 STInstallation and Maintenance ManualNOTICEBefore closing the winch, make sure the holes and drainage channels in the base of the win