Harken 35.2PT Winche Manual do Utilizador

Radial Winch 35.2 PTInstallation and Maintenance ManualMRW-01

10Radial Winch 35.2 PTInstallation and Maintenance Manual8. Remove the drum support n°15Important: washer n°12 may remain inside the drum support!10.

11Radial Winch 35.2 PTInstallation and Maintenance Manual14. Remove the pawls n°5. To facilitate the operation press the spring against the pawl with

12Radial Winch 35.2 PTInstallation and Maintenance ManualExploded view with maintenance products1Apply Harken® grease on assy socket screw 2Apply Hark

13Radial Winch 35.2 PTInstallation and Maintenance ManualAssemblyMake sure that the holes and drainage channels in the base of the winch are not obstr

14Radial Winch 35.2 PTInstallation and Maintenance ManualHeadquartersHarken®, Inc.1251 East Wisconsin AvenuePewaukee, Wisconsin 53072-3755 USATel: (26

15Radial Winch 35.2 PTInstallation and Maintenance ManualExploded view 1/2213914410136511712819

16Radial Winch 35.2 PTInstallation and Maintenance ManualExploded view 2/2232230282729212616151817202524

17Radial Winch 35.2 PTInstallation and Maintenance Manual*Service kit available; see winch kit section on the website www.harken.com**Winch product st

2Radial Winch 35.2 PTInstallation and Maintenance ManualIntroductionTechnical characteristicsWeightMaximum working loadOutlineInstallationProcedure 1P

3Radial Winch 35.2 PTInstallation and Maintenance ManualIntroduction - Technical characteristics - OutlineIntroductionThis manual gives technical info

4Radial Winch 35.2 PTInstallation and Maintenance ManualInstallationThe winch must be installed on a at area of the deck, reinforced if necessary to

5Radial Winch 35.2 PTInstallation and Maintenance ManualThe winch can be installed following one of the two procedures below (Procedure1 or Procedure

6Radial Winch 35.2 PTInstallation and Maintenance ManualProcedure 2To install, you must remove the winch skirt and use hexagonal headed bolts.Tools ne

7Radial Winch 35.2 PTInstallation and Maintenance ManualNOTICEMake sure the skirt is correctly clipped on to the base of the winch. Install the winch

8Radial Winch 35.2 PTInstallation and Maintenance Manual B. Remove the winch and drill the ve 6.2 mm diameter holes.C. Bolt the base of the winch to

9Radial Winch 35.2 PTInstallation and Maintenance ManualWARNING!Periodic maintenance must be carried out regularly. Lack of adequate maintenance short