Harken 3813 System AA Battcar Manual do Utilizador

Please read these instructions carefully before installing, servicing, or operating the equipment. This manual may be modified without notice. See: ww

Installation – CB System (Slug Mount) Install Track 10 System AA (CB)7. Hold full-length track piece up to mast. Loosely install top screw.Use p

27072711Preassembly/Installation – CB System (Drill & Tap) Parts/Remove Track/Install Track System AA (CB)

12 System AA (CB) 2. Drill track hole, holding drill perpendicular to mast face. Tap threads and install screws using blue Loctite®. 3. Align t

System AA (CB) 13IMPORTANT! Keep balls captive by loading cars onto track without sail installed. Car must ha

Load Cars with SailLine up car on guide portion of loader. Press car towards mast and carefully roll car onto track. Begin with upper cars and work d

System AA (CB) 15Operation – CB System (Slug Mount/Drill & Tap) Load Sail on Cars1. Beginning with lower cars,

Car Maintenance/CleaningClean beginning of season, or if cars bind.Squirt detergent and water into ball bearings. Circulate by moving cars up and down

3814AED3813ADE3816DCBAEFInstalling 3813 Headboard Coupler Car Assembly3813 headboard coupler attaches to standard headboards—some headboard modificati

Distance Between Attachment PointsBattens and intermediate cars placed at sailmaker's discretion. Maximum distance between attachment points is

System AA (CB) 19General Maintenance (see specific maintenance on page 16)Harken equipment is desig

2 System AA (CB) Introduction WARNING! Strictly follow all instructions to avoid potential hazards that may kill or hurt you and others. Se

Printed in USA 4247 10/14Corporate HeadquartersN15W24983 Bluemound Rd, Pewaukee, WI 53072 USATelephone: (262) 691-3320 • Fax: (262) 701-5780Web:

3813Part No. Description IncludesMounting slug method3818, 3819 3820Track Mounting Kit(a) 19 x mounting slugs 19 mm (3/4"); (b) 1 x connector slu

SizingMake sure that you have the correct size battcar system for your boat.Sail ModificationsSee page 12 - 13. 1. Mainsail Headboard A. Drill new

System AA (CB) 5Round track length to nearest 1" (25 mm). Note: Chart is based on using 3817 track–length 2.05m (6'8 7/

2. Deburr cut. Slightly round track corners that will slide against mast.1. Cut special length top track from 2.05 m (6'8 3/4") track.3. Dri

System AA (CB) 7Preassembly – CB System (Slug Mount) Check Fit of Mounting Slugs/CarsClear of Storm Trysail Track

1. Slip top track slugs into mast groove. Use 19 mm (3/4") mounting slug for top stop. Note: If top track is 30 mm (1 3/16"), use 67 mm (2

Installation – CB System (Slug Mount) Install Track System AA (CB) 94. Slide slugs into place with putty knife.