Harken 3852 System B CB & Slider Battcars: built 2007 Manual do Utilizador

Battcar Installation ManualSystem B CB – 10mm Clevis Pin System B Slider CarsWARNING!: Strictly follow all instructions to avoid an accident, damage

4. Attach head of sail to headboard car with clevis pin and cotter pin.2. Screw threaded stud to terminal.3. Load toggle using 5mm allen wrench and 1

HARKENHARKENLazy JacksUse shock cord to hold lazy jacks open so battcars and battens will not catch on them. This will also help stop slapping of laz

Dimensions (measured from aft face of mast) E F Part A B C D Pin Ø Stud Ø No. Descri

3-07 System B (CB/Slider) 13 CB System Installing Headboard Car Assembly CB/Sliders Systems Sailmakers InstructionsHalyard Attachment HoleUse aft

Distance Between Attachment PointsBattens and intermediate cars placed at sailmaker's discretion. Maximum distance between attachment points is

CB/Slider Systems Installation Troubleshooting4286/6-06 System B (CB/Slider) 15Problem Probable Cause SolutionCut end of top or bottom track is at

Printed in USA 4286/7-09Corporate Headquarters1251 East Wisconsin Avenue, Pewaukee, Wisconsin 53072 USA Telephone: (262) 691-3320 • Fax: (262) 691-3

Part No. Description Includes3845, 3846Track Mounting Kit (a) 19 mounting slugs 7/8" (22mm); (b) 1 connector slug 3" (76mm); (c) 2 Tubes Blu

SizingMake sure that you have the correct size battcar system for your boat.Sail Modifications (See page 12)CB HeadboardWeb on headboard.Slider Headbo

Round track length to nearest 1" (25 mm). NOTE: Chart is based on using a 93/8" (238 mm) or 91/2" (241 mm) lower end track.CB/Slider S

2. Deburr cut. Slightly round track corners that will slide against mast.1. Cut special length top track from 6'91/8" (2.06m) track.5 or mor

1. Slip top track slugs into mast groove. Use 17/16" (36mm) mounting slug for top stop. Short top track lengths Top slug 11/2" (38 mm) 3&q

7. Hold full-length track piece up to mast. Loosely install top screw.Use putty knife to slide additional slugs and connector slug into place. Loosely

Required Parts1616 TrackDetermine Track Length. Bottom track must be short enough to remove easily. Use 18" to 24" (457mm to 609 mm) lengt

CB System Load Cars on TrackSlider System Load Cars on Track Part Length Bearing Quantity Ball ø Number Car Type in mm Col