Harken C8436 MKIV Jib Reefing & Furling Manual do Utilizador

NAUTOR MKIV Jib Reefing & Furling Installation ManualC8436/C8437

Start plunger into injector and immediately hold upright so plunger is down and tip applicator is up.As sealant runs down towards the plunger an air

Tighten screws into connector holes. Make sure that a drop of adhesive was put in screw holes. If not, apply to screw.Use bushings, connector, wedge a

Continue installing connectors and wedges. Make sure to use adhesive in screw holes.Continue assembly. Use 14" (356mm) bottom connector to asse

Loosen foil clamp screws at top of lower unit.Slide drum assembly onto foils.Tip: Face clamp downwards so it clears foil notches when installing.Sli

Make sure halyard swivel and drum assem-bly have been slipped on the foils.Slip the rod adapter sleeve onto the rod.Sandwich the nosepiece over the ro

Lower drum assembly and slip clevis pin and cotter pin in place.Check foil height at top, set and secure using Allen wrench.Hammer the pin into the ma

Check the clearance between the top of the foil and top terminal.TIP: Check clearance when the unit is on the ground, before raising the headstay into

Race ConversionRace conversion allows use of both grooves for sail changes and tacking genoas on deck for use of maximum luff length genoas.Halyard

HALYARD WRAPSThe most serious problem with furling systems occurs when the jib halyard wraps around the headstay foil. Halyard wraps will prevent furl

PENDANTSIf your sail is not long enough to position the halyard swivel properly, you must add a pendant to the sail. Pendants should be plastic coated

Corporate HeadquartersN15W24983 Bluemound Rd, Pewaukee, WI 53072 USATelephone: (262) 691-3320 • Fax: (262) 701-5780Web: www.harken.com • Email: harke

Bottom ConnectorConnectorsPart No. Quantity Description7413.30C8436 (9)7'(2.13m) FoilC8437 (10)7413.33 1 2'(610mm) Botton foil (shipped in d

HEADSTAY CUT LENGTHSubtract the following from the headstay length and cut the stay at that point.HEADSTAY CUT LENGTH6.5 mmPreassembly Headstay Lengt

FOIL CUT LENGTH Foil cut length is based on pin-to-pin length as measured from cen-ter of upper pin (attaches the stay to the mast) to center of lower

Deburr inside edge using a rat-tail file.Cut foil to length using a hacksaw. Tip: Mark top foil to distinguish from cutoff piece.Lay top foil alongsi

Lay top foil in line with others. Slide stay into top foil and down the line of foils or slide each foil up stay.Cut out template at right. Line templ

Place halves of plastic bushings on stay so hooked part of longer section faces out.Tip: With foil screw holes up as shown below, place longer half of

Slip 9.75" (248mm) connector on wire, mating hook of plastic bushing with connector.Tip: In cooler weather, keep sealed adhesive in pocket to